Audi A4, S4

since 2000 of release

Repair and car operation



Audi A4, S4
+ Introduction
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
- Body
   General information and security measures at carrying out body works
   Cleaning and leaving
   Repair of insignificant damages of body panels
   Repair of considerable damages of a body
   + External equipment
   - Salon equipment
      Remarks on work with the salon and security measure equipment
      Removal and installation of spring clips
      Removal and installation of the central console
      Removal and installation of the holder of drinks
      Removal and installation of facing of the lever of the parking brake
      Removal and installation of a cover of the lever of switching of transfers/selector
      Removal and ashtray installation
      Removal and installation of the central armrest
      Removal and installation of an internal mirror
      Removal and cover installation on a control panel
      Removal and pocket installation from the driver
      Removal and installation of a ware box
      Removal and installation of an antisolar peak
      Removal and installation of facing are resistant And
      Removal and installation of the top facing of a rack In
      Removal and installation of the bottom facing of a rack In
      Removal and installation of a forward overlay of a threshold
      Removal and installation of facings (Sedan)
      Removal and installation of facings (Versatile person)
      Removal and installation of a forward seat
      Removal and installation of a back seat
      Removal and installation of a forward seat belt
      Removal and installation of a back seat belt
+ Onboard electric equipment


f6be02a9

Removal and installation of facing are resistant And

Removal

 PERFORMANCE ORDER

At a detachment of cables of system of a safety cushion surely observe security measures at the address with a safety cushion, address to the Section General information and security measures.

    To exclude operation a head safety cushion, switch off ignition and disconnect at first the negative (-), and then positive cables of the storage battery. Instructions are provided in the Section Replacement of the storage battery.
    Remove a solar peak, address to appropriate section.
 
    Press down the handle (5) and cast away down a screw cover (4). For this purpose enter into a groove (7) thin wire and open a cover.
    Turn out screws (2). Take out a cover (9) of facing (1) and turn out the screw being behind it. Disconnect facing (1) at spring clips (3) grooves (6) in a rack And and extend under facing of a rack of Century. Remove back from the dashboard facing of a rack And (1).

Installation

 PERFORMANCE ORDER

    Insert facing under door consolidation (8) and press directing pad (10) in the holder of a clip. Thus watch the correct provision of a sealant of a door. Press facing at spring clips (3) and fix. Insert facing of a rack And under facing of a rack of Century. Check, that the clip and hooks of the adapter of a safety cushion were reliably fixed. Screw the screw behind and press a cover (9) into facing. Fix the handle new being self-stopped screws (2). Close a screw cover.

During connection of the storage battery in salon there should not be people.

    Remove an insulating tape from the negative plug of the storage battery, attach at first positive (+), and then a negative cable (-) to a battery battery room.

Observe indications of the Section Replacement of the storage battery.