Audi A4, S4

since 2000 of release

Repair and car operation

External equipment

Installation of the forward panel in situation for maintenance

1 — the Forward panel 2 — the Top cover of the engine, left 3 — the Top cover of the engine, right 4 — the Screw, 10Нм 5 — the Screw, 50Нм	3369 — the Provision of service: Screw the special AUDI tool in openings in a bumper. Instruction: If the specified special tool available is not present, it is possible to apply 2 M8 screws x 90. Under a head of a bolt it is necessary to enclose washers in diameter of 24 mm and thickness of 2 mm. Besides, 2 plugs in length of 80 mm and diameter of 17 mm are necessary.

At carrying out some adjusting works, for example, with a maple or gear belt the forward panel should be established in situation for an obsluzhivniya. Thus the panel is displaced together with a radiator forward.

PERFORMANCE ORDER

Disconnect air lines (1) and (2) between the forward panel and the air filter on the forward panel (shooters on сопр. illustrations). Remove the top cover of the engine at the left (2) and on the right (3), address to an illustration at the beginning of the section. Disconnect the bottom cover of the engine ahead, without removing it. For this purpose unscrew only 3 screws. Remove a front bumper, address to appropriate section. Screw in two top openings on the right and at the left the special tool 3369. Turn out screws (5) at the left and on the right, address to an illustration at the beginning of the section. Turn out screws (4) at the left and on the right. Pull forward the forward panel so that the back opening on the panel was closed by a forward carving opening on a wing. In this situation screw at the left and on the right a bolt (the shooter on an accompanying illustration) and fix the panel.