Audi A4, S4

since 2000 of release

Repair and car operation


Audi A4, S4
+ Introduction
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
- Body
   General information and security measures at carrying out body works
   Cleaning and leaving
   Repair of insignificant damages of body panels
   Repair of considerable damages of a body
   - External equipment
      Installation of the forward panel in situation for maintenance
      Removal and installation of a cover of a water modular compartment
      Removal and installation of a front bumper
      Removal and installation of a loker of a back wing
      Removal and installation of a loker of a forward wing
      Removal and installation of a forward wing
      Removal and installation of a rear bumper
      Removal and cowl installation/adjustment
      Removal and installation of a cable of a drive of a cowl
      Removal and installation of a clamp of the lock
      Removal and installation of facing of a forward door
      Removal and installation of facing of a back door
      Removal and door installation
      Door adjustment
      Removal and installation of a frame of a window of a forward door
      Removal and window regulator installation
      Removal and installation of the electric motor of a drive of a window regulator
      Removal and installation of the lock of a door
      Removal and installation of the handle of a door
      Removal and installation of the cylinder of the lock of a door
      Removal and installation of facing of a trunk lid
      Removal, installation and trunk lid adjustment
      Removal and installation of the lock of a luggage carrier
      Removal and installation of facing of a door of a back (Versatile person)
      Removal and installation of a door of a back (Versatile person)
      Removal and installation of the lock of a door of a back (Versatile person)
      Removal and installation of an external mirror
      Removal and installation of moldings
      Removal, installation and check of the movable panel of a roof
      Removal and installation of an overlay of the movable panel of a roof
      Check and adjustment of a starting position of the movable panel of a roof
      Removal and installation of a sealant of the movable panel
      Replacement of elastic bands of brushes of a screen wiper
      Removal and installation of a jet of a stekloomyvatel of a windscreen
      Removal and installation of a jet of a washer of back glass
      Removal and installation of the lever of a cleaner of a windscreen
      Removal and installation of the lever of a cleaner of back glass
      Removal and installation of jets of a faroomyvatel
      Adjustment of levers of a screen wiper
   + salon Equipment
+ Onboard electric equipment

f6be02a9

Removal and installation of a door of a back (Versatile person)

Removal

 PERFORMANCE ORDER

    Disconnect a negative cable (-) the storage battery.

Observe indications of the Section Replacement of the storage battery.

    Remove facing of a door of a back, address to the Section Removal and installation of facing of a door of a back (Versatile person). Disunite sockets of heating of back glass and a screen wiper, and also the uniform lock. Disconnect a hose of a washer of back glass.

For simplification of installation it is necessary will fix on the wire ends a cord which after a pulling of wires remains in a cover.

Surely ask the assistant to take a door of a back before removing a gas-filled emphasis. Otherwise the door can fall, since it cannot keep only at the expense of one damper.

    Disconnect above a gas-filled emphasis (1). For this purpose raise a screw-driver a lock spring (3) a little and remove an emphasis from a spherical pin (2). The second emphasis remove in the same way.
    Remove covers of loops and directing for a cable, located at a loop. For the subsequent installation: Mark with a felt-tip pen the provision of loops of a door of a back.
    Turn out screws (arrows on an accompanying illustration) at the left and on the right from a back door.
    Remove a door by means of the assistant.

Installation

 PERFORMANCE ORDER

    Establish a door by means of the assistant on loops. An old door expose thus on earlier executed labels. Screw screws at the left and on the right. Establish a gas-filled emphasis on a spherical support and insert a lock ring. In the same way establish the second emphasis. Weaken a lock clamp, close a door and adjust it in relation to adjacent elements. Tighten screws the moment 21Нм. Further installation is carried out in sequence, return to removal. Attach a negative cable (-) the storage battery.

Observe indications of the Section Replacement of the storage battery.

Back door: Check/adjustment

 PERFORMANCE ORDER

    Check gaps in interface of a door of a back to adjacent elements of a body. Gaps on all perimeter should be uniform. The door should coincide with lateral elements of a back part of a body. Over a roof the door should not act more than 0.5 mm.
    Unscrew nuts (1) and (3) so that the clamp of the lock (2) could be displaced.

The pad (on an accompanying illustration) on a clamp shows the shooter back.

    Uncover (1) on the left and right emphasis, and establish the adjusting screw (2), having turned it counter-clockwise, in situation "0".
    Close a door and press it on 2 mm into a body. Open a door and tighten nuts the moment 21Нм. The door should be closed on the lock easily and not have люфта. Check gaps.
    Adjust the provision of the left and right emphasis so that the closed door had no люфта. For this purpose put on an emphasis a little plasticine and close a door. On a print of plasticine it is possible to judge, whether the door is correctly adjusted
    Establish on a cover emphasis.