Check and adjustment of a starting position of the movable panel of a roof Installation of the electric motor of the movable panel in a starting position
|
|
Close the movable panel.
Remove a forward ceiling plafond, address to the Section Removal and installation of plafonds of internal lighting.
Unscrew screws of fastening and remove the electric motor of the movable panel.
Electric wires of the electric motor do not disconnect.
Include ignition.
Establish the rotary switch situation «A roof it is closed». Thus the electric motor works automatically and stops in zero situation.
In this situation establish the electric motor at the closed roof and fix it.
Establish a forward plafond.
|
|
Check of a starting position of the kulisny directing
|
|
|
|
The starting position can be checked by means of a pocket mirror and a pocket lamp at the established movable panel. |
|
Remove lateral slips at the left and on the right, address to appropriate section.
|
Open and again close the movable panel.
|
Shift the ceiling panel completely back.
|
Put on the movable panel a pocket mirror and check a starting position. At the correct installation a rectangular groove in the mechanism of promotion kulisny directing (1) should coincide with a groove (an arrow on an accompanying illustration). Otherwise make adjustment.
|
|
|
Installation of the directing coulisse in a starting position
|
|
Remove the movable panel.
Remove the panel electric motor.
Remove lateral slips, address to appropriate section.
Displace kulisny directing (1) from both parties from back situation forward.
Establish a rectangular groove in the mechanism of promotion kulisny directing (1) so that it coincided with a groove (shooter) on the directing tire (2) panels of a ceiling. Thus the starting position of the directing coulisse is established.
Establish the electric motor of the movable panel in a starting position.
Establish lateral slips.
|
|
|
