Audi A4, S4

since 2000 of release

Repair and car operation



Audi A4, S4
+ Introduction
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
- Body
   General information and security measures at carrying out body works
   Cleaning and leaving
   Repair of insignificant damages of body panels
   Repair of considerable damages of a body
   - External equipment
      Installation of the forward panel in situation for maintenance
      Removal and installation of a cover of a water modular compartment
      Removal and installation of a front bumper
      Removal and installation of a loker of a back wing
      Removal and installation of a loker of a forward wing
      Removal and installation of a forward wing
      Removal and installation of a rear bumper
      Removal and cowl installation/adjustment
      Removal and installation of a cable of a drive of a cowl
      Removal and installation of a clamp of the lock
      Removal and installation of facing of a forward door
      Removal and installation of facing of a back door
      Removal and door installation
      Door adjustment
      Removal and installation of a frame of a window of a forward door
      Removal and window regulator installation
      Removal and installation of the electric motor of a drive of a window regulator
      Removal and installation of the lock of a door
      Removal and installation of the handle of a door
      Removal and installation of the cylinder of the lock of a door
      Removal and installation of facing of a trunk lid
      Removal, installation and trunk lid adjustment
      Removal and installation of the lock of a luggage carrier
      Removal and installation of facing of a door of a back (Versatile person)
      Removal and installation of a door of a back (Versatile person)
      Removal and installation of the lock of a door of a back (Versatile person)
      Removal and installation of an external mirror
      Removal and installation of moldings
      Removal, installation and check of the movable panel of a roof
      Removal and installation of an overlay of the movable panel of a roof
      Check and adjustment of a starting position of the movable panel of a roof
      Removal and installation of a sealant of the movable panel
      Replacement of elastic bands of brushes of a screen wiper
      Removal and installation of a jet of a stekloomyvatel of a windscreen
      Removal and installation of a jet of a washer of back glass
      Removal and installation of the lever of a cleaner of a windscreen
      Removal and installation of the lever of a cleaner of back glass
      Removal and installation of jets of a faroomyvatel
      Adjustment of levers of a screen wiper
   + salon Equipment
+ Onboard electric equipment


f6be02a9

Removal and installation of facing of a back door

Door facing

1 — door Facing
2 — the Decorative level
3 — Screws, 4 pieces.
4 — the Cover
5 — the window regulator Handle, a manual drive

6 — the Screw
7 — Razzhimnaya a nut, 4 pieces.
8 — the Tightening nut, 4 pieces.
9 — the window regulator Switch
Depending on the equipment.

Removal

 PERFORMANCE ORDER

    Disconnect a negative cable (-) the storage battery.

Observe indications of the Section Replacement of the storage battery.

    Disconnect from facing a decorative level (2) and remove it forward. Turn out 4 screws (3). Manual window regulator: Remove the handle of a window regulator (5). Enter a plastic wedge around clips between the panel of a door and facing and remove facing from a door. Take away facing from a frame of a door a little and disconnect a cable of a drive of a door, address to the Section Removal and installation of facing of a forward door. Disunite the socket of the switch of a window regulator (9). Remove facing from a door frame.

Installation

 PERFORMANCE ORDER

    Before installation check correctness of provision of tightening nuts (8) and razzhimny nuts (7) on a door frame. Installation is carried out in sequence, return to removal. Thus pay attention that the hook (3) drafts shows upward. Manual window regulator: Establish into place the window regulator handle. Attach a negative cable (-) the storage battery.

Observe indications of the Section Replacement of the storage battery.

Window regulator handle

Removal

 PERFORMANCE ORDER

    Enter a screw-driver between a cover (4) and the window regulator handle. Uncover the window regulator handle. Turn out the screw (6) and remove the handle.

Installation

 PERFORMANCE ORDER

    Establish the window regulator handle in situation «at 6 o'clock» (± 15 °) at the closed window on a handle axis.