Audi A4, S4

since 2000 of release

Repair and car operation



Audi A4, S4
+ Introduction
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
- Body
   General information and security measures at carrying out body works
   Cleaning and leaving
   Repair of insignificant damages of body panels
   Repair of considerable damages of a body
   + External equipment
   - Salon equipment
      Remarks on work with the salon and security measure equipment
      Removal and installation of spring clips
      Removal and installation of the central console
      Removal and installation of the holder of drinks
      Removal and installation of facing of the lever of the parking brake
      Removal and installation of a cover of the lever of switching of transfers/selector
      Removal and ashtray installation
      Removal and installation of the central armrest
      Removal and installation of an internal mirror
      Removal and cover installation on a control panel
      Removal and pocket installation from the driver
      Removal and installation of a ware box
      Removal and installation of an antisolar peak
      Removal and installation of facing are resistant And
      Removal and installation of the top facing of a rack In
      Removal and installation of the bottom facing of a rack In
      Removal and installation of a forward overlay of a threshold
      Removal and installation of facings (Sedan)
      Removal and installation of facings (Versatile person)
      Removal and installation of a forward seat
      Removal and installation of a back seat
      Removal and installation of a forward seat belt
      Removal and installation of a back seat belt
+ Onboard electric equipment


f6be02a9

Removal and installation of a back seat belt

Removal

 PERFORMANCE ORDER

    Switch off ignition and disconnect at first the negative (-), and then positive cables of the storage battery. Stick the negative plug of the storage battery with an insulating tape. Instructions are provided in the Section Replacement of the storage battery. Sedan: Remove facing of a rack by D, address to appropriate section. Sedan: remove the shelf, address to appropriate section. Sedan: Remove a dempfiruyushchy element under the shelf. Remove lateral facing of a luggage carrier / a cargo compartment, address to appropriate section.
    Turn out the screw (2) at the device for belt (1) taking-up, and also a bolt (5) at a belt tip.
    Disunite the socket (7) and disconnect a device cable for a belt tension from the holder (4). (8) – a cover of protection against noise. Extend the device for taking-up of a belt (1) of lock openings (3) and take out together with a seat belt.

Installation

 PERFORMANCE ORDER

    Installation is carried out in sequence, return to removal. Thus watch the correct laying of a cable of a belt. Tighten bolts (2) and (5) moment 55Нм.

During connection of the storage battery in salon there should not be people.

    Remove isolating tape from a negative pole of the storage battery, attach at first positive (+), and then a negative cable (-) to a battery battery room.

Observe indications of the Section Replacement of the storage battery.

Back directing a belt

Removal

 PERFORMANCE ORDER

    Remove a lateral pillow of a back seat, address to the Section Removal and installation of a back seat. Remove a seat belt.
    Take out a detail from polyfoam (4).
    Turn out 2 bolts (2) and take out directing a belt (1) of lock openings.

Installation

 PERFORMANCE ORDER

    Installation is carried out in sequence, return to removal. Thus both washers (3) should lie over lock openings. Directing for a belt it should be fixed distinctly.