General information on control The term "control" is used in this Management rather for designation of a complex of procedures, than one separate procedure. If from the moment of car purchase the schedule of routine maintenance is strictly observed, frequent checks of level of liquids and a condition subject to the increased wear a component as it is offered in this Management will be carried out, the engine will long remain in a good working condition, and need for carrying out any additional work will be minimized. Is more often, however, happens so that the engine works inefficiently owing to neglect with regular service. Even more often it happens upon purchase of the second-hand car which owners did not trouble themselves with frequent and regular checks and service. In this case, besides performance of usual procedures on routine maintenance, it will be necessary to make setup of the engine. The first step in any procedure of control or diagnostics for the purpose of improvement of operation of the engine is check of extent of compression in cylinders. Compression check (address to Head the Engine) will help to define a condition internal a component of the engine and should serve as the index at carrying out control and repair. If, for example, check of extent of compression indicates serious internal wear of the engine, usual control will not help to improve its work and will be waste of time and money. As procedure of check of extent of compression is the extremely important, the expert owning the equipment specially intended for this purpose should see off her. For engine reduction in a good working condition performance of the following procedures more often is required. Minimum settings
General settings
|