Audi A4, S4

since 2000 of release

Repair and car operation



Audi A4, S4
+ Introduction
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Specifications
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Rassoyedineniye of sockets
   Check of the electric motor of a screen wiper
   Check of warmed back glass
   Check of stoplights
   Removal and installation of a sound signal
   Removal and installation of sensors of a parking
   Replacement of the battery of a remote control of the ignition key
   Relay and safety locks
   Replacement of filament lamps of devices of external lighting
   Removal and installation of headlights
   Removal and installation of the lateral repeater of turns
   Removal and installation of an additional stoplight
   Removal and installation of a back lamp
   Removal and installation of a lamp of illumination of registration plate
   Removal and installation of plafonds of internal lighting
   Removal and installation of a control panel
   Removal and installation of the podrulevy switch
   Removal and installation of switches of a forward door
   Removal and installation of the switch of light
   Removal and installation of the switch of a window regulator in a back door
   Removal and installation of the switch of a trunk lid
   Removal and installation of the switch of the parking brake
   Removal and installation of the switch of illumination of a ware box
   Removal and installation of switches of the central console
   Removal and radio receiver installation / navigation device/CD-чейнджера
   Removal and installation of loudspeakers
   Removal and installation of aerials
   Removal and installation of the tank of liquid стеклоомывателя / pump electric motor
   Removal and installation of the electric motor of a cleaner of a windscreen
   Removal and electric motor installation on back glass (Versatile person)
   The uniform lock - the general information
   Removal and installation of a locking element of a cover of a fuel tank
   Digital tire of data of CAN
   + Schematic diagrams of electric equipment


f6be02a9

Removal and installation of aerials

Sedan

Removal

 PERFORMANCE ORDER

    Disconnect a negative cable (-) the storage battery.

Observe indications of the Section Replacement of the storage battery.

    Remove closing level of a roof, address to the Section Removal and installation of facing of a forward door.
    Disconnect lock clips (arrows on an accompanying illustration) and remove the aerial (1) from a roof.
    Disunite the socket (2) aerials.

Installation

 PERFORMANCE ORDER

    Installation is carried out in sequence, return to removal.

Versatile person

Removal

 PERFORMANCE ORDER

    Disconnect a negative cable (-) the storage battery.

Observe indications of the Section Replacement of the storage battery.

    Remove a plafond of a cargo compartment, address to the Section Removal and installation of plafonds of internal lighting.
    Remove closing level of a roof, address to the Section Removal and installation of facings (Versatile person).
    Disunite sockets (2) and (3).
    Unscrew a nut (1) and remove the aerial from a roof.

Installation

 PERFORMANCE ORDER

    Further installation is carried out in sequence, return to removal. Thus carry out an antenna wire through a groove in a washer of a nut (1). Join sockets according to labels available on them.

Aerial радиочасов

Removal

 PERFORMANCE ORDER

    Remove a rear bumper, address to the Section Removal and installation of facings (Versatile person).
    Disconnect an antenna cable (3) from the aerial (2).
    Turn out screws (1) and remove the aerial from the holder of a bumper.

Installation

 PERFORMANCE ORDER

    Installation is carried out in sequence, return to removal.