Check of warmed back glass At inclusion of heating of back glass the field with visible lines of wires should be released after a while from a covering or snow.
|
|
In the presence of malfunctions check at first a safety lock in the block of safety locks.
If a safety lock as it should be, remove facing of back glass and check reliability of connection of the tip at glass at the left and on the right. If necessary clear of corrosion.
If heating still does not work, check the control unit comfort electric equipment.
If conductors of a heater are torn, it is possible to use a usual current-carrying varnish for repair. For this purpose clear the damaged place a thinner or ethylene.
Paste over the damaged place from both parties with a gluing tape and put with a small brush a current-carrying varnish.
Dry paint at temperature near +25°С within 24 hours. For this purpose it is possible to apply also hot air. At temperature +150°С paint dries within 30 minutes.
|
|
Do not include heating of back glass before paint completely will not dry. To cleaning of the damaged elements do not apply gasoline or other solvents. |
|
|
|
