Audi A4, S4

since 2000 of release

Repair and car operation


Audi A4, S4
+ Introduction
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
- Coupling, power shafts and differential
   - Coupling
      General information
      Removal, installation and coupling check
      Removal and bearing installation
      Air removal from hydrosystem of a drive of coupling
   + Power shafts of wheels
   + Models with a full drive of wheels
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

f6be02a9

Removal and bearing installation

Bearing of switching off of coupling

1 — A CHECK POINT
2 — the Spherical pin. Grease with MoS 2 greasing. The tightening moment at a check point from an aluminum alloy: 25Нм; at a check point from a magnesian alloy: 18Нм.
3 — the Intermediate element
4 — Tarelchataya a spring. Smaller diameter is turned to directing plug
5 — the Sealing ring
6 — the Cuff of primary shaft. Press against the stop
7 — Directing втулка*
8 — the Lock spring
9 — the Lever of the bearing of switching off of coupling. Before installation a pusher grease with copper Z 381 351 TE greasing

10 — the Screw with internal Torx*. Surely replace Black for a check point from the aluminum alloy, shining for a check point of a magnesian alloy. The tightening moment for a check point from an aluminum alloy: 35Нм; the tightening moment for a check point from a magnesian alloy: 25Нм.
11 — the Bearing of switching off of coupling. Do not wash out, only wipe
12 — the Bolt, 20Нм
13 — the Working cylinder of hydrosystem of a drive of coupling. At installation press the cylinder so that it was possible to enter a bolt easily
14 — the Pusher. Grease the end with copper greasing