Audi A4, S4

since 2000 of release

Repair and car operation

Audi A4, S4
+ Introduction
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
- Coupling, power shafts and differential
   + Coupling
   - Power shafts of wheels
      General information
      Removal and installation of a power shaft
      Dismantling of a power shaft and replacement of a protective cover
   + Models with a full drive of wheels
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Power shafts of wheels

General information

Power shaft with the Tripode AAR 2000 hinge

1 — the Bolt, surely replace
2 — the Collar, surely replace
3 — the Protective cover of the external hinge. Check on existence of cracks and places of retyrannies. Before fixing of collars quickly raise a cover to level pressure
4 — the Collar, surely replace
5 — the Screw with an internal polyhedron
6 — the Hinge
7 — «Tripode» Star with rollers. The facet (arrow) specifies on a shlitsa of a shaft
8 — the Lock ring, surely replace
9 — the Round sealing ring
10 — the Cover
11 — the Collar
12 — the Protective cover of the Tripode hinge. Before fixing of collars quickly raise a cover to level pressure. The hinge thus should be in the central situation
13 — the Shaft
14 — the Lock ring. Surely replace the Lock ring insert into a shaft groove.
15 — the External hinge. Replace only in a set. On a shaft it is established by means of a plastic hammer so that the lock ring was fixed.
Attention: At cover replacement the hinge, if necessary, to fill with greasing. Pay attention to distinction in greasing grades depending on diameter of the hinge.
*) six-sided case

Power shaft with the hinge of equal angular speeds

1 — the Bolt, surely replace
2 — the External hinge of equal angular speeds, replace only in a set
3 — the Lock ring. Surely replace. Before installation of the hinge it is inserted into a shaft groove. If the hinge is established, the ring is not visible
4 — the Collar
5 — the Cover of the external hinge. Check on existence of cracks and places of retyrannies. In the presence of damages of the hinge check it outside. Before fixing of collars quickly raise a cover to level pressure. Before fixing of collars quickly raise a cover to level pressure. Sealing surfaces at installation of covers should be cleared of greasing
6 — the Shaft
7 — the Cover, surely replace

8 — Consolidation, surely replace
9 — the Lock ring. Surely replace. It is inserted into a shaft groove
10 — the Internal hinge. Replace in a set. Surfaces under glue should be cleared of greasing and oil
11 — Podkladnaya a plate
12 — the Screw with an internal polyhedron
13 — the Cover with a cover. In the presence of damages check the internal hinge. A cover check on existence of cracks and places retyranny. Replace only in a set. Sealing surfaces at installation should be cleared of greasing and oil

The car is actuated by means of torque transfer from a transmission to wheels by means of two (or four – on models with a full drive) power shafts. Boots of internal hinges are made of rubber, and external — from thermoplastic (thermoplastic is steadier against external influences). Each shaft consists of three main parts: internal hinge (tripod type), directly shaft and external hinge of equal angular speeds (CV JOINT). The internal hinge of a shaft is fixed by means of a lock ring. External hinges of both shaft (CV JOINTS) terminate in shlitsevy shaft which enter in a shlitsa of naves of driving wheels. Shaft are fixed in naves by nuts.