Audi A4, S4
+ Introduction
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
- Coupling, power shafts and differential
+ Coupling
- Power shafts of wheels
General information
Removal and installation of a power shaft
Dismantling of a power shaft and replacement of a protective cover
+ Models with a full drive of wheels
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of a power shaft Removal
|
|
Remove a cap closing a wheel, a decorative cap or caps of bolts of fastening of wheels.
Unscrew on a corner 90 ° a bolt of fastening of the external hinge of a power shaft.
|
|
|
Bolt weaken, when the car costs on wheels. Danger of accident! |
|
Note shooters the direction of rotation of wheels. Unscrew bolts of fastening of a wheel. Lift and establish the car on supports and remove a wheel.
Again wrap by hand all five bolts of fastening of a wheel.
Turn out a bolt of fastening of the external hinge of a power shaft.
Disconnect a power shaft from a flange shaft/check point.
|
If the sufficient place is not present to take out a power shaft, execute the following: unscrew a nut (1), unscrew a bolt and take out upward both levers (2).
|
|
|
|
Do not expand a groove in the case of the bearing of a wheel by means of a chisel or the tool similar to it. |
|
Take aside the case of the bearing of a wheel.
|
|
|
Bolts (3) and (4) do not turn on, since adjustment of a forward suspension bracket in this case will change and the running gear should be regulated again. |
|
Take out a power shaft.
|
|
Installation
|
|
Insert a power shaft into the case of the bearing of a wheel.
Establish into place both top levers. Establish a new bolt and tighten a new nut the moment 40Нм. At an inhaling of a nut press on the suspension bracket lever in the direction of the case of the bearing of a wheel as far as it is possible.
Fix a power shaft on an axis/check point flange with podkladny plates. Tightening moment: Bolt М8 – 40Нм, a bolt of M 10 - 70Нм.
Fix the external hinge of a power shaft a new bolt. Tightening moments: Bolt М14 – 115Нм, bolt М16 – 190Нм.
|
|
At a bolt inhaling the car can not concern the basis. |
Observe the direction of rotation of wheels. Fix a wheel, lower the car on wheels and only after that tighten bolts cross-wise the moment 120Нм.
Ask the assistant to tighten the parking brake.
Tighten a bolt of fastening of a power shaft, tighten a bolt on a corner 180 °.
Establish into place a cap closing a wheel, a decorative cap or caps of bolts of fastening of wheels.
|
|
|
|
