Audi A4, S4
+ Introduction
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
- Systems of electric equipment of the engine
+ ignition and engine management System
+ System of preheat of the diesel engine
+ Diagnostics of systems of electronic control and diagnostic equipment
- Charging and start systems
General information
The storage battery - the main data and acquisition of the new battery
Check and charging of the storage battery
Replacement of the storage battery
Storage of the storage battery
Charging system - general information and security measures
Check of system of a charging
Removal and generator installation
Removal and regulator installation tension/replacement of brushes
System of start of the engine - the general information and precautionary measures
Removal and starter installation
Check of system of start of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and regulator installation tension/replacement of brushes Removal
|
|
Remove the generator, address to appropriate section.
|
|
|
Depending on model removal of a regulator possibly also on the established generator. |
|
Unscrew nuts on connecting plugs.
Turn out screws and remove a protective cover from the generator.
|
|
|
Depending on model generators of various executions can be established. |
|
Turn out screws and take out a regulator aside.
Replace brushes, for what отпаяйте a rope.
Check wear of rings, if necessary pierce them and polish (work HUNDRED).
|
|
|
Installation
|
|
Insert new brushes (And) and springs (In) in a shchyotkoderzhatel (C) and solder contacts.
|
|
To exclude solder hit in a rope at the soldering, clamp a brush rope flat-nose pliers.
|
|
|
At solder hit ropes become rigid and brushes unsuitable for work. |
|
Establish into place a regulator of tension and fix it.
After installation of new brushes check them on ease of a course.
Fix on the generator a protective cover.
Screw nuts on connecting plugs.
Establish into place the generator, address to the Section Removal and generator installation.
|
|
|
|
