Audi A4, S4
+ Introduction
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
- Suspension bracket and steering
Security measures at work
+ Suspension bracket of forward wheels
+ Suspension bracket of back wheels
+ Corners of installation of wheels of the car
- Steering and safety cushions
General information and security measures
Removal and installation of the block of a safety cushion
Removal and installation of a steering wheel
Removal and installation of a tip of steering draft
Removal and installation of a protective cover of the steering mechanism
+ Body
+ Onboard electric equipment
|
Removal and installation of a tip of steering draft Removal
|
|
Mark on the tire the direction of its rotation. Unscrew bolts of fastening of a wheel. Lift and establish on supports a forward part of the car and remove a wheel.
|
Turn out a bolt (1).
|
|
Unscrew a nut (5) and turn out a bolt (2).
|
|
|
Do not expand shlitsa in the case of the bearing of a wheel with a chisel or any other similar tool. |
|
|
Do not apply a chisel or any similar tool to removal of steering draft by its zabivaniye between the pendular lever (1) and a sealing washer (2) tips of steering draft. Steering draft can act in film only by a vypressovka of the end of a pin of a tip from the steering lever or blows of a wooden or rubber hammer. |
|
Remove steering draft down.
|
|
Unscrew a lock-nut (3) and turn out a tip from steering draft.
|
Wipe a tip of steering draft and a terminal opening on the case of the bearing of a wheel.
|
|
Installation
|
|
Screw a tip on steering draft against the stop.
Tighten a lock-nut (3) moment 40Нм. HUNDRED AUDIS apply for this purpose the V.A.G 1332/12 tool. At an inhaling keep steering draft from a provorachivaniye for a shestigrannik (4).
Expose steering draft so that the pin of a tip was in the provision of installation.
|
Insert steering draft against the stop into the pendular lever.
|
|
|
|
Steering draft insert into the pendular lever (1) only by hand, thus do not press strongly on a sealing washer (2) tips. |
|
Insert a bolt (2) and screw a new nut (5), tighten a nut the moment 50Нм.
|
|
Establish a bolt (1) and tighten it the moment 7Нм.
|
Establish and fix a wheel, observing the direction of its rotation. Lower the car and only after that tighten bolts cross-wise the moment 120Нм.
Carry out measurements of a running gear of the car (work HUNDRED).
|
|
|
|
