Audi A4, S4

since 2000 of release

Repair and car operation


Audi A4, S4
+ Introduction
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
- Systems of electric equipment of the engine
   + ignition and engine management System
   - System of preheat of the diesel engine
      General information
      Removal and installation of candles of an incandescence
      Check of candles of an incandescence
   + Diagnostics of systems of electronic control and diagnostic equipment
   + charging and start Systems
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

f6be02a9

Check of candles of an incandescence

If at start of the engine there are difficulties, it is necessary to check functioning of all candles of an incandescence.

At check the engine should be cold (ambient temperature), the storage battery - is completely charged (tension not less than 11.5 In).

Check of giving of a food

This check is carried out at the established glow plugs.

 PERFORMANCE ORDER

    Remove the top covers of the engine, address to the Section Removal and installation of the top cover of the engine / the bottom protection of an impellent compartment/stretcher. Disunite sockets of candles of an incandescence, for example, by means of a special clip of HAZET 4760-5. Include a control lamp between contact of a cable and weight. Include ignition, warm up the engine. Leave the ignition key in position of preheat and watch a lamp. The lamp should light up. Similarly check a food at all candles of an incandescence. Join sockets of candles of an incandescence.

Check of candles of an incandescence

 PERFORMANCE ORDER

    Consistently put an ohmmeter to each glow plug and check, whether passes an electric current between the block of cylinders and a glow plug. If the current does not pass (0 W), the glow plug has damage and it is necessary to replace it. Join sockets of candles of an incandescence. Establish into place the top covers of the engine, address to the Section Removal and installation of the top cover of the engine / the bottom protection of an impellent compartment/stretcher.