Audi A4, S4

since 2000 of release

Repair and car operation


Audi A4, S4
+ Introduction
+ Governing bodies and receptions of safe operation
+ Current leaving and service
+ Engine
+ Systems of cooling, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
- Manual box of gear shifting
   Specifications
   Removal and check point installation
   Check of level of oil in a manual check point
   Adjustment of a drive of gear shifting
   Check of adjustment of the lever of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

f6be02a9

Check of level of oil in a manual check point

 PERFORMANCE ORDER

    Establish the car on an equal platform. Lift and establish the car on a platform.
    Turn out a stopper for filling with oil depending on execution by a face key on 10 mm, for example, HAZET 985-10 or a face key under a polyhedron, for example, to AUDI-3357 or HAZET 2567-16. The stopper is located at the left on a check point under the sensor of a measuring instrument of speed and can be closed by the heat-shielding screen of a power shaft.
    Check oil level by means of a wire bent at an angle. Level of oil should be on 7 mm below the bottom edge of an opening for an oil flood.

Filling also to level of the bottom edge of an opening is allowed. Apply only synthetic oil specified in Specifications.

    Tighten a stopper the moment 25Нм.

Stopper different for a check point from aluminum and magnesian alloys.